Portable Feeder Specs & Installation
Portable Feeder includes:
1 Portable Feeder frame
Dimensions: 24” x 24”
Adjusts to fit fence rails 24-28” apart
B. Slide a clevis pin through one hole on the side of the access hole, then THROUGH the loop of the hay net, and out the opposite side until the pin clicks into place.
C. Repeat steps so that hay net is evenly distributed around HayPal.
Installing a hay net onto Portable Feeder
A. Using your finger, push one loop of the hay net into an access hole (see picture). Position the loop of the net so that it will remain inside the access hole for the next step.
A. Detach bottom brackets (left and right) by removing the clevis pin and pulling out the adjustable bracket.
Mounting the Portable Feeder
B. Place the feeder OVER the fence, gate or stall wall of your choice. Slide the hay net through the applicable fence rail.
C. Replace bottom brackets by inserting one into each side, pushing the bracket up as far as it will go, and replacing the clevis pin. As this product is produced in small lots, do not switch the left and right brackets.